Sliding bearing
is surface contact, so the contact surface to maintain a certain oil
film, so the design should pay attention to the following questions.
1, to make the oil film can smoothly into the friction surface.
2, the oil should be from the non-bearing area into the bearing.
3, do not make the whole ring oil tank open in the middle of the bearing.
4, such as oil tiles, seams open oil ditch.
5, to make the oil ring to the oil is fully reliable.
6, do not be blocked oil hole.
7, do not form the oil does not flow area.
8, to prevent cutting off the sharp edges and edges of the oil film.
CATEGORIES
Latest news
- Ferrofluid Vacuum Feedthrough Seals us
- Which one is wear-resistant, steel sle
- Bimetal Flange Bush Bearing
- Selection standard for dimension refer
- Red color ptfe bushing
- Pipe-Mounted Ball Transfer
Contact us
- ADD: No.503,Hunan International Commerce Center, Jintai Square,Changsha 410001,Hunan.
- TEL: +86 731 84770165
- FAX: +86 731 84770163
- E-mail: sales1@slide-bearing.com
> Industry news